MIPI CSI Transmitter

MIPI Complaint

The MIPI Camera Serial Interface 2 (CSI-2) specification defines an interface between a peripheral device (camera) and a host processor (baseband, application engine). This interface is defined by MIPI consortium, which defines a series of modules in a MIPI compliant product.

GDA MIPI CSI Transmitter is used in mobile and high –speed serial applications where a camera can send the video data using it over MIPI lines to the MIPI CSI Receiver for decoding the data and use it for subsequent processing. MIPI CSI Transmitter adheres to MIPI CSI Specification. The GDA MIPI CSI Transmitter along with GDA MIPI DPHY provides a complete solution for encoding MIPI data.

Design Attributes
• Highly modular design
• Fully synchronous design
• Active low Asynchronous reset

Product Package
• RTL code
• Detailed design document
• Verification environment
• Test cases
• Synthesis environment/scripts

Documentation
• Design Guide
• Synthesis guide

GDA Technologies Inc. is a leading Electronic Design Services (EDS) and Silicon Intellectual Property (SIP) solution provider for the Embedded, Networking, and Consumer Electronics Markets. GDA is focused on designing IC and board level products from concept to implementation. GDA has successfully developed products in areas of high-speed communications, Digital Video, Internet Appliances, and Mobile Solutions.

Features
Compliant with MIPI CSI Spec v1.01.00 Rev 0.03 and      MIPI D-PHY Spec v0.9   Programmable 1, 2 or 4 Data Lane Configuration.   Operate in continuous and non-continuous clock     modes.   Command and Video Mode (Burst and Non-Burst     mode) support	Video Stream Packet Formats: YUV 422 8-bit, RGB888,     RGB565, RAW8, RAW10, RAW12   Progressive Scanning   Camera Interface: 8, 16 and 24 bit per pixel   Data Rate: 800 Mbps per lane on silicon (Spec mentions a     max of 500 Mbps per lane)

 

Availability : Now
Language : Verilog HDL
Synthesis : Design Compiler
FPGA          : Xilinx ISE on Virtex Simulation Modelsim, Verilog NC